If the rectangles were not cleanly cut with minimal overcut, then the operator simply didn't have the machine properly calibrated. The acute angles on some lettering fonts can be handled better by some CMC's than others. If you are trimming out the majority of openings by hand after cutting, then you need to adjust your (measuring stop) settings, as the constant trimming process can produce glitches in the corners even more noticeable than a minute overcut.ĬMC's can be adjusted Rock, to eliminate and minimize overcuts. (Hey.even Brian Wolf, the Master of hand control on his carved mats, uses stops on a manual mat cutter!)Īs Ron indentified, you want to achieve an extremely small overcut that cannot be noticed. Your approach to minimize overcuts in your everyday results by using stops is absolutely spot on! Measuring stops, when calibrated accurately will always yield more consistent results. Then again, I guess it makes the rest of us who care about doing good work look much better to our customers. The vender needs to get the CMC set up correctly or don't bother selling junk mats. Then again, maybe their customers are so wrapped up looking at how cool their school name is cut in the mat that they don't take time to see the overcuts. You wouldn't think a vender would sell stuff like that. But I sure wouldn't take the money to buy a CMC only to put out a bunch of overcuts with it. They very rarely if ever go out the door in my shop. Like most framers, I hate overcuts and do all I can do to prevent them. Is this a setup thing on a CMC, or are they all prone to overcuts? Since I don't have a CMC yet is the reason I'm asking. Overcuts on every one of the ones I looked at, some really bad ones over a quarter inch long. I was greatly disappointed looking at the quality. VinylMaster Cut and other popular software (like Sure Cuts Alot, Flexi. I was at a fall festival this past weekend and there was a vender with a lot of college named mats along with some peoples names, all cut with a CMC. The search for the ultimate best vinyl cutting machine for the money is a tough.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |